107. Engineering Drawing 


Learning drafting codes as per ISO and IS preparation and use of scales, 
Technical lettering			-one plate.
Projection of points and strainght lines.					-one plate.
Projection of simple solids, cylinders, cones, parallelopiped & pyramids 
in orthographic and isometric projections.  -3 plates
Section of simple solids.					- one plate

Simple cases of interpenetration of solids and 
development of plane and curved surfaces.				-3 plates

Introduction, construction of nomograms, Histograms, and frequency distribution, 
determination of mean, median, mode 
Perspective projection- Principles of perspective projection by orthographic method 
and vanishing point 
(one and two vanishing point perspective projection of simple solids.


Texts / References